Presentations
The following presentations were given at the Aerospace Power and Electronics Simulation Workshop held in Cleveland, Ohio on October 8, 2003.
The presentations are in Adobe Portable Document Format (PDF) . To view the presentations, you will need the free Adobe® Acrobat® Reader®. 
|
- Frequency Response Analysis for DC-DC Converters Without Small-Signal Linearization
Kasemsan Siri - The Aerospace Corporation - Integrated Systems/Subsystems Modeling for Aerospace Applications
S. Johnny Fu, PhD, P.E. - Boeing Phantom Works - Engineering in the 21st Century
Charles Alexander - Cleveland State University - Modeling and Analysis of Signal Estimation for Stepper Motor Control
Dan Simon - Cleveland State University - Challenges of Designing High Power Converter for Aerospace Applications
Kaz Furmanczyk - ELDEC Corporation - Advancing Position Sensor Design Using Maxwell and Optimization
Kevin Woolsey - ELDEC Corporation - FEA analysis of a brushless starter/generator exciter using Maxwell 2D
Mark W. Bailey - Goodrich Corporation - 15000 RPM Turbo Generator
Andrew Hirzel - LE Incorporated - Use of Maxwell for Simulation of Magnetically Levitated Propulsor
Dawn Emerson - NASA Glenn Research Center - Development of a Three Phase Filter for a 60,000 RPM Flywheel System
Long V. Truong - NASA Glenn Research Center - Performance Prediction for a Permanent Magnet Two-Pole Synchronous Machine for a Flywheel Energy Storage System
Narayan Dravid - NASA Glenn Research Center - Concurrent Engineering Design Practice for Aerospace Power
Raymond F Beach - NASA Glenn Research Center - Free-Piston Stirling Convertor Controller Development at NASA Glenn Research Center
Timothy Regan - Sest, Inc. - Integrating the Design Environment
Paul Tsutsumi, Don Baxter, David Nguyen - Northrop Grumman - Power Losses in Magnetic Bearings Controlled by High Frequency Switching Power Amps
Andrew Kenny - Texas A&M University
Ray Beach - NASA GRC
Alan Palazzolo - Texas A&M University
